KORADO, a.s.RADIK CLEAN VK - Steel Panel Radiator
Description
The RADIK CLEAN VK model is a steel panel radiator in the VENTIL KOMPAKT version, which allows for bottom right connection to the heating system distribution mains. It is designed for pressurised heating systems.
It has been modified for installation and operation in rooms with greater demands on hygiene and cleanliness. All types are supplied without additional surfaces, grilles and side covers. Two upper and two lower fixing hangers are welded to the back, radiators 1800 mm in length or longer have six fixing hangers welded to the back. Basic equipment includes air vent and blanking plug and the required number of type 18/120 drill-in brackets (see KORAMONT catalogue),which allow for fixing of the radiator in a standard manner at a distance of up to 65 from the wall.
Important notice:
If there is a requirement for the distance of the radiator from the wall within the range 65 ÷ 80 mm, the same type of brackets
can be used, but a condition is use of brackets on the lower row of fixing lugs too (not supports). In this case, these further
brackets must be ordered, as they are not included in the basic equipment.
Note:
The RADIK CLEAN VK type 10 and RADIK VK type 10 radiators are identical.
- Recommended Equipment
- Heat Output (
PDF, 85 kB) - Basic Technical Parameters ( PDF, 38 kB)
- RADIK Calculation of heat output
- Radiator accessories RADIK
Technical data
| Height H | 300, 400, 500, 600, 900 mm | ||
| Length L | 400, 500, 600, 700, 800, 900, 1000, 1100, 1200, 1400, 1600, 1800, 2000, 2300, 2600, 3000 mm |
||
| Depth B | |||
| - Type 10 CLEAN VK | 47 mm | ||
| - Type 20S CLEAN VK | 66 mm | ||
| - Type 30 CLEAN VK | 155 mm | ||
| Connecting pitch | 50 mm | ||
| Connecting thread | 6 x G½ inside | ||
| Highest allowed working pressure | 10 bar | ||
| Highest allowed working temperature | 110 °C | ||
| Radiator connection | right bottom | ||
Types of connection
 |
| right bottom φ = 1 |
Overview of Types
| Type 10 CLEAN VK |  |
|---|---|
| Type 20S CLEAN VK |  |
| Type 30 CLEAN VK |  |
Pressure Loss
In case of two-pipe heating system it is necessary to calculate the correct level of valve presetting and specify this in the project documentation to ensure a proper function of the heating system. This must be kept by the installer during installation of the heating system.
In case of one-pipe heating system it is necessary to set the valve at level 6. For adjusting the required mass flow in the radiator we recommend to use the compact connecting fitting with a fixed or adjustable flow volume of water in the radiator.
